Hakko De-soldering Equipment

Static-free design - ESD Safe.

Excellent desoldering tool for multilayer PCBs.

Efficient heat transfer allows a lower element temperature, for safe desoldering of multilayer boards.

Fast & strong suction power to remove solder from the narrower holes of multilayer PCBs.

Ideal for the technician or engineer working away from their work-bench. The Hakko 808 is a compact all-in-one desoldering tool with excellent desoldering performance.

The unique Hakko design places the pump & motor above, not inside, the grip so vibration is minimal and the grip is thin and easy to hold.

The miniature, high-performance diaphram pump is housed in the pump chamber at the rear of the unit, making pump maintenance quick & easy - simply remove the cover of the pump chamber.

Supplied complete with a A1005 1.0mm nozzle.

The all-in-one ESD safe system for soldering & desoldering.

Combines a powerful desoldering tool with a high performance soldering station with accurate control for more effective repair work.

Compact unit requires little bench space.

The complete ESD safe multipurpose electronic workstation.

Twin independantly controlled soldering irons (900S & 907), high performance desoldering tool & hot air SMD rework tool.

Direct heating has less influence upon surrounding components on crowded boards.

Easily removes SMD chips and flat pack's up to 25mm.

The collet allows easy replacement and alignment of the tips.

Supplied with a A1378 2.0mm tip set.

Operates with 701 or 702B base (not supplied).

Soldering iron tips oxidise between use, and may become blackened and unusable if kept at high temperature for a long time.

The Hakko 599B has wires coated with flux, and no water is required. The tip temperature does not drop due to water during the cleaning.

It is also an effective method to remove oxidisation.

Draw out the solder wire smoothly.

ESD safe by design.

Keep your bench neat.

Up to 1kg roll bobbin. Shaft dia. 15mm.

Hakko 611-1 holds 1 reel.

Hakko 611-2 holds 2 reels.

Fast accurate tip temperature measurements using a fine CA wire sensor (dia. 0.2)

Large easy to read temperature display (°C).

Quick and easy sensor replacement.

Low-noise, high performance fan.

The filter is made by combining a specific urethane foam with refined activated carbon to give high absorbency.

The body is made with a non sloughing static dissipative, conductive material.

A C1023 arm stand (not shown) is ideal for positioning a smoke absorber above the soldering area.